ADTRAN AOS Version R10.1.0 Command Reference Manual page 1702

Command Reference Guide
snmp trap
Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface. Us the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and subinterfaces) have SNMP traps
enabled.
Command History
Release 1.1
Release 5.1
Release 6.1
Release 8.1
Release 16.1
Release A4.01
Usage Examples
The following example enables SNMP capability on the Ethernet interface:
(config)#interface ethernet 0/1
(config-eth 0/1)#snmp trap
60000CRG0-35E
Command was introduced.
Command was expanded to include the Ethernet subinterfaces and Gigabit
Ethernet interfaces.
Command was expanded to include the port channel and virtual local area
network (VLAN) interfaces.
Command was expanded to the asynchronous transfer mode (ATM)
interface.
Command was expanded to the tunnel interface.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet Interface.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
1702