ADTRAN AOS Version R10.1.0 Command Reference Manual page 1726

Command Reference Guide
switchport port-security violation
Use the switchport port-security violation command to configure the action to be taken once a security
violation is encountered. Use the no form of this command to return to the default setting. Variations of
this command include:
switchport port-security violation protect
switchport port-security violation restrict
switchport port-security violation shutdown
Syntax Description
protect
restrict
shutdown
Default Values
The default for this command is shutdown.
Command History
Release 8.1
Usage Examples
The following example configures the interface to react to security violations by not learning the addresses
and not accepting data from the violation source:
(config)#interface ethernet 0/1
(config-eth 0/1)#switchport port-security violation restrict
60000CRG0-35E
Determines that the unit will not learn any new secure addresses (nor allow
these new sources to pass traffic) until the number of currently active
secure addresses drops below the maximum setting.
Determines that the security violation counter increments and an Simple
Network Management Protocol (SNMP) trap is sent once a violation is
detected. The new address is not learned and data from that address is not
allowed to pass.
Determines that the interface is disabled once a violation is detected. A no
shutdown command is required to re-enable the interface.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
1726