Fdl Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
FDL I
NTERFACE
FDL Interface Configuration mode is used for establishing a Telnet session over the FDL (facility data
link). To activate, enter the interface fdl command and specify the associated slot/port number (of the T1
interface used) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface fdl 1/1
(config-fdl 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
ip address <ipv4 address> <subnet mask> on page 1742
ip address range <start ipv4 address> <end ipv4 address> <subnet mask> secondary on page
1743
ip learn-address on page 1744
ip mtu <size> on page 1745
peer default ip address <ipv4 address> on page 1747
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

FDL Interface Command Set

1741