Fxo Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
FXO I
NTERFACE
To activate the Foreign Exchange Office (FXO) Interface Configuration mode, enter the interface fxo
command and specify the FXO port at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface fxo 0/1
(config-fxo 0/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
impedance on page 1749
loopback on page 1750
rx-gain <value> on page 1751
test erl on page 1752
test loop on page 1754
test ring-ground on page 1755
test tip-ground on page 1756
test tone on page 1757
tx-gain <value> on page 1758
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

FXO Interface Command Set

1748