Ipv6 Nd Prefix - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

ipv6 nd prefix

Use the ipv6 nd prefix command to specify the Internet Protocol version 6 (IPv6) address prefixes used in
router advertisement (RA) messages sent from the interface. Use the no form of this command to remove
the specified prefix configuration from the interface. Variations of this command include:
ipv6 nd prefix [<ipv6 prefix/prefix-length> | default]
ipv6 nd prefix [<ipv6 prefix/prefix-length> | default] [no-advertise]
ipv6 nd prefix [<ipv6 prefix/prefix-length> | default] [<valid lifetime> | infinite] [<preferred lifetime> |
infinite]
ipv6 nd prefix [<ipv6 prefix/prefix-length> | default] [no-advertise] [<valid lifetime> | infinite]
<preferred lifetime | infinite>
ipv6 nd prefix [<ipv6 prefix/prefix-length> | default] [<valid lifetime> | infinite] [<preferred lifetime> |
infinite] [no-advertise] [no-autoconfig] [no-rtr-address] [no-onlink] [off-link]
Syntax Description
<ipv6 prefix/prefix-length>
default
<valid lifetime>
<preferred lifetime>
infinite
no-advertise
no-autoconfig
no-rtr-address
no-onlink
off-link
Default Values
By default, all prefixes derived from the interface's configured IPv6 addresses are advertised using the
system default values.
60000CRG0-35E
Specifies the IPv6 prefix and length to be advertised. Pv6 prefixes should
be expressed in colon hexadecimal format (X:X::X/<Z>). For example,
2001:DB8:3F::/64. The prefix length (<Z>) is an integer with a value
between 0 and 128.
Specifies the default values for the IPv6 prefix parameters. Refer to the
Functional Notes below for more information.
Optional. Specifies the valid lifetime to advertise for this route in each RA
message. Range is 0 to 4294967295 seconds.
Optional. Specifies the preferred lifetime to advertise for this route in each
RA message. Range is 0 to 4294967295 seconds.
Optional. Specifies that the the valid and preferred lifetimes of the prefix do
not expire.
Optional. Specifies that the prefix is excluded from the RA message.
Optional. Sets the A flag in the RA message to 0, indicating that hosts may
not create an address for this prefix using stateless address
autoconfiguration (SLAAC). This parameter only affects hosts receiving the
RA message, it does not affect the operation of the local router.
Optional. Sets the R flag in the RA message to 0 and specifies the full router
IPv6 address is not included in the RA message.
Optional. Specifies that the IPv6 prefix in the RA message is not to be used
for on-link determination.
Optional. Sets the L flag value to 0 in RA messages, which indicates the RA
makes no statement about the on-link or off-link properties of the IPv6
prefix.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
1674