ADTRAN AOS Version R10.1.0 Command Reference Manual page 1793

Command Reference Guide
awcp
Use the awcp command to enable ADTRAN Wireless Control Protocol (AWCP) on this interface. The
AWCP is an ADTRAN proprietary protocol used by an access controller (AC) to communicate with an
access point (AP). Use the no form of this command to disable AWCP for this interface.
Syntax Description
No subcommands.
Default Values
By default, AWCP is enabled on the interface.
Command History
Release 15.1
Release A4.01
Functional Notes
When the global-level command dot11ap access-point-controller (refer to
on page 941 for more information) is enabled, the AWCP function can be disabled on a specific interface
by using the no form of this command from the desired interface. When the global-level command
dot11ap access-point-controller is disabled, it overrides the awcp command setting for the interface.
Usage Examples
The following example disables AWCP on the MEF Ethernet interface 0/1:
(config)#interface mef-ethernet 0/1
(config-mef-ethernet 0/1)#no awcp
60000CRG0-35E
Command was introduced.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet interface.
Copyright © 2012 ADTRAN, Inc.
MEF Ethernet Interface
dot11ap access-point-control
1793