Table of Contents
Advertisement
Command Reference Guide
switchport port-security
Use the switchport port-security command to enable port security functionality on the interface. Use the
no form of this command to disable this feature.
Syntax Description
No subcommands.
Default Values
This command is disabled by default.
Command History
Release 8.1
Functional Notes
You cannot enable port security on a port that is already configured as the following:
•
Monitor session destination
•
Member of a port channel interface
•
Dynamic or trunk port (i.e., the port must be configured as static access)
Usage Examples
The following example enables port security on the Ethernet interface 0/1 interface:
(config)#interface ethernet 0/1
(config-eth 0/1)#switchport port-security
60000CRG0-35E
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
1720
Advertisement
Table of Contents
