ADTRAN AOS Version R10.1.0 Command Reference Manual page 1736

Command Reference Guide
vlan-id <vlan id>
Use the vlan-id command to set a virtual local area network (VLAN) ID for the Ethernet interface. Use the
no form of this command to remove an entry. Variations of this command include:
vlan-id <vlan id>
vlan-id <vlan id> native
Syntax Description
<vlan id>
native
Default Values
By default, no VLAN ID is set.
Command History
Release 6.1
Release A4.01
Usage Examples
The following example configures a native VLAN of 5 for the Ethernet interface 0/1:
(config)#interface ethernet 0/1
(config-eth 0/1)#vlan-id 5 native
60000CRG0-35E
Specifies a valid VLAN interface ID number. Range is 1 to 4095.
Optional. Specifies that data for that VLAN ID goes out untagged. If native is
not specified, data for that VLAN ID goes out tagged.
Command was introduced.
Command was expanded to include the Metro Ethernet Forum (MEF)
Ethernet subinterface.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
1736