ADTRAN AOS Version R10.1.0 Command Reference Manual page 1779

Command Reference Guide
coding
Use the coding command to configure the line coding for the G.703 physical interface. This setting must
match the line coding supplied on the circuit by the private branch exchange (PBX). Use the no form of
this command to return to the default setting. Variations of this command include:
coding ami
coding hdb3
Syntax Description
ami
hdb3
Default Values
By default, all E1 interfaces are configured with HDB3 line coding.
Command History
Release 5.1
Functional Notes
The line coding configured in the unit must match the line coding of the E1 circuit. A mismatch will result in
line errors (e.g., bipolar violations (BPVs)).
Usage Examples
The following example configures the G.703 interface for AMI line coding:
(config)#interface e1 1/2
(config-e1 1/2)#coding ami
60000CRG0-35E
Configures the line coding for alternate mark inversion (AMI).
Configures the line coding for high-density bipolar 3 (HDB3).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
G.703 Interface Command Set
1779