Command Reference Guide
spanning-tree bpdufilter
Use the spanning-tree bpdufilter command to enable or disable the bridge protocol data unit (BPDU)
filter on a specific interface. This setting overrides the related global setting (refer to
edgeport bpdufilter default on page
setting. Variations of this command include:
spanning-tree bpdufilter disable
spanning-tree bpdufilter enable
Syntax Description
disable
enable
Default Values
By default, this setting is disabled.
Command History
Release 5.1
Functional Notes
The bpdufilter blocks any BPDUs from being transmitted and received on an interface.
Usage Examples
The following example enables the BPDU filter on the Ethernet interface 0/3:
(config)#interface ethernet 0/3
(config-eth 0/3)#spanning-tree bpdufilter enable
The BPDU filter can be disabled on the Ethernet interface 0/3 by issuing the following commands:
(config)#interface ethernet 0/3
(config-eth 0/3)#spanning-tree bpdufilter disable
60000CRG0-35E
1343). Use the no form of this command to return to the default
Disables BPDU filter for this interface.
Enables BPDU filter for this interface.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
spanning-tree
1704