Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
G.703 I
NTERFACE
To activate the G.703 Interface Configuration mode, enter the interface e1 command (and specify the
G.703 port) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface e1 1/2
(config-e1 1/2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
coding on page 1779
framing crc4 on page 1780
loopback network on page 1781
snmp trap link-status on page 1782
test-pattern on page 1783
ts16 on page 1784
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.
G.703 Interface Command Set
1778