Table of Contents
Advertisement
Command Reference Guide
Ethernet Interface Command Set
port-auth multiple-hosts
Use the port-auth multiple-hosts command to allow multiple hosts to access an authorized port without
going through the authentication process. This command is only applicable when authentication is port
based. Use the no form of this command to return to the default setting.
Syntax Description
No subcommands.
Default Values
By default, this command is disabled.
Command History
Release 10.1
Command was introduced.
Usage Examples
The following example enables multiple hosts to access an authorized port:
(config)#interface ethernet 0/1
(config-eth 0/1)#port-auth multiple-hosts
60000CRG0-35E
Copyright © 2012 ADTRAN, Inc.
1695
Advertisement
Table of Contents
