ADTRAN AOS Version R10.1.0 Command Reference Manual page 1770

Command Reference Guide
signal
The signal command configures the signaling mode for the foreign exchange station (FXS) interface. Use
the no form of this command to return to the default value. Variations of this command include:
signal ground-start
signal loop-start
Syntax Description
ground-start
loop-start
Default Values
By default, this command is set to loop-start.
Command History
Release 6.1
Functional Notes
This signaling mode must match the configuration of the network.
Usage Examples
The following example sets the signaling mode to loop-start:
(config)#interface fxs 2/1
(config-fxs 2/1)#signal loop-start
60000CRG0-35E
Applies resistance to the tip conductor of the circuit to indicate an off-hook
condition.
Bridges the tip and ring to indicate an off-hook (seizing the line) condition.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
FXS Interface Command Set
1770