Table of Contents
Advertisement
Command Reference Guide
switchport trunk native vlan <vlan id>
Use the switchport trunk native vlan command to set the virtual local area network (VLAN) native to the
interface when the interface is in trunking mode. To return to defaults, use the no form of this command.
Syntax Description
<vlan id>
Default Values
By default, this is set to VLAN 1.
Command History
Release 5.1
Functional Notes
Configure which VLAN the interface uses as its native VLAN during trunking. Packets from this VLAN
leaving the interface will not be tagged with the VLAN number. Any untagged packets received by the
interface are considered a part of the native VLAN ID.
Usage Examples
The following example sets the native VLAN on Ethernet interface 0/1 to VLAN 2:
(config)#interface ethernet 0/1
(config-eth 0/1)#switchport trunk native vlan 2
60000CRG0-35E
Specifies a valid VLAN interface ID. Range is 1 to 4094.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
1731
Advertisement
Table of Contents
