ADTRAN AOS Version R10.1.0 Command Reference Manual page 1747

Command Reference Guide
peer default ip address <ipv4 address>
Use the peer default ip address command to specify the default Internet Protocol version 4 (IPv4) address
of the remote end of this interface. Use the no form of this command to remove a default IP address.
Syntax Description
<ipv4 address>
Default Values
By default, there is no assigned peer default IPv4 address.
Command History
Release 3.1
Release 7.1
Functional Notes
This command is useful if the peer's FDL interface is on a different subnet than the local unit's FDL
interface IPv4 address. This is common if the FDL interface is unnumbered to another interface's IPv4
address.
Usage Examples
The following example sets the default peer IPv4 address to 192.22.71.50:
(config)#interface fdl 1/1
(config-fdl 1/1)#peer default ip address 192.22.71.50
60000CRG0-35E
Specifies the default IPv4 address for the remote end. IPv4 addresses
should be expressed in dotted decimal notation (for example, 10.10.10.1).
Command was introduced.
Command was expanded to include the facility data link (FDL).
Copyright © 2012 ADTRAN, Inc.
FDL Interface Command Set
1747