Table of Contents
Advertisement
Command Reference Guide
switchport access vlan <vlan id>
Use the switchport access vlan command to set the port to be a member of the virtual local area network
(VLAN) when in access mode. To reset the port to be a member of the default VLAN, use the no form of
this command.
Syntax Description
<vlan id>
Default Values
By default, this is set to VLAN 1 (the default VLAN).
Command History
Release 5.1
Functional Notes
If the port is in the trunk mode, this command will not alter the switchport mode to access. Instead it will
save the value to be applied when the port does switch to access mode. Refer to
1719
for more information.
Usage Examples
The following example sets the switchport mode to static access and makes the Ethernet interface 0/1 port
a member of VLAN 2:
(config)#interface ethernet 0/1
(config-eth 0/1)#switchport mode access
(config-eth 0/1)#switchport access vlan 2
60000CRG0-35E
Specifies a valid VLAN interface ID. Range is 1 to 4094.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Ethernet Interface Command Set
switchport mode on page
1717
Advertisement
Table of Contents
