Hssi Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
HSSI I
NTERFACE
To activate the High Speed Serial Interface (HSSI) Interface Configuration mode, enter the interface hssi
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface hssi 1/1
(config-hssi 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
external-loopback-request on page 1786
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 1787
loopback on page 1788
snmp trap link-status on page 1789
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

HSSI Interface Command Set

1785