Mef Ethernet Interface - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
MEF E
THERNET
The Metropolitan Ethernet Forum (MEF) Ethernet interface is a virtual interface used by AOS products to
interface with the Metro Ethernet Network (MEN) and carrier Ethernet technologies. The MEF Ethernet
interface functions as the user-network interface (UNI) in AOS products with the second-generation
Ethernet in the First Mile (EFM) network interface modules (NIMs). The MEF Ethernet interface is used
as the Layer 2 and 3 wide-area network (WAN) interface. For more information about configuring the
MEF Ethernet interface as part of the EFM NIM2 configuration, refer to the configuration guide
Configuring EFM NIM2s and the MEF Ethernet Interface in AOS available online at
https://supportforums.adtran.com.
To activate the basic MEF Ethernet Interface Configuration mode, enter the interface mef-ethernet
<slot/port> command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface mef-ethernet 0/1
(config-mef-ethernet 0/1)#
To activate the basic MEF Ethernet Subinterface Configuration mode, enter the interface mef-ethernet
<slot/port.subinterface> command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface mef-ethernet 0/1.1
(config-mef-ethernet 0/1.1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
arp arpa on page 1792
awcp on page 1793
bandwidth <value> on page 1794
crypto map <name> on page 1795
dynamic-dns on page 1797
encapsulation 802.1q on page 1799
60000CRG0-35E
I
NTERFACE
Copyright © 2012 ADTRAN, Inc.

MEF Ethernet Interface

1790