User Register Descriptions - STMicroelectronics SPC572L series Reference Manual

RM0400
Offset
address
0x0040
0x0044
0x0048
0x004C
0x0050
0x0054
0x0058 User Multiple Input Signature 0 register (UM0)
0x005C User Multiple Input Signature 1 register (UM1)
0x0060 User Multiple Input Signature 2 register (UM2)
0x0064 User Multiple Input Signature 3 register (UM3)
0x0068
0x006C
0x0070
0x0074
0x0078 User Multiple Input Signature 8 register (UM8)
0x007C User Multiple Input Signature 9 register (UM9)
0x0080 Over Program Protection 0 (OPP0)
0x0084 Over Program Protection 1 (OPP1)
0x0088 Over Program Protection 2 (OPP2)
0x008C
0x0090 Test Mode Disable Password Check (TMD)
1. Reset value comes from UTEST area within TestFlash, and this assumes the location is erased and all possible blocks are
available.
2. Note that R/W register may contain some read only or write only bits.
29.3.2

User register descriptions

This section consists of user register descriptions in address order.
29.3.2.1 Module Configuration Register (MCR)
The Module Configuration Register is used to enable and monitor all the Modify operations
of the Flash Memory module.
Table 297. Flash User Registers memory map(Continued)
Description
Select 2 register (SEL2)
Reserved
Reserved
Reserved
Address Register (ADR)
User Test 0 register (UT0)
Reserved
Reserved
Reserved
Reserved
Reserved
DocID027809 Rev 4
Embedded Flash Memory (MP55)
(1)
Access Reset value
R/W 0x0000_0000
— —
— —
— —
R 0x0000_0000
R/W 0x0000_0001
R/W 0x0000_0000
R/W 0x0000_0000
R/W 0x0000_0000
R/W 0x0000_0000
— —
— —
— —
— —
R/W 0x0000_0000
R/W 0x0000_0000
R 0x0000_0000
R 0x0000_0000
R 0x0000_0000
— —
R/W —
Location
on page 616
—
—
—
on page 617
on page 619
on page 622
on page 622
on page 623
on page 623
—
—
—
—
on page 624
on page 624
on page 625
on page 626
on page 627
—
on page 628
599/2058
644