Table 75. Voltage Monitors Configurability - STMicroelectronics SPC572L series Reference Manual

Power management
1. REE: Reset event enable. IE: Interrupt enable — See
(PMC_dig).
Table 75
POWER PHASE
UP 0-1-2
ENABLE ENABLE
ENABLE DISABLE ENABLE
ENABLE DISABLE ENABLE
ENABLE DISABLE DISABLE DISABLE
ENABLE DISABLE DISABLE DISABLE
228/2058
provides the monitor status depending on configuration.

Table 75. Voltage monitors configurability

(1)
DCF REE RES
— —
ENABLE DEST
ENABLE FUNC
DocID027809 Rev 4
Chapter 54: Power Management Controller digital interface
(2) (3)
IE
Default configuration (boot threshold monitor)
— —
– Monitor full run from power-up to power-down
– Monitor power-up, gate exit from power-up
phase.
– Monitor disabled on phase0 entry.
– Monitor re-enabled in PHASE 3 on DCF rec
— reading.
– Trigger destructive event reset during reset
flow.
– Configuration is locked to enable during run
time.
– Monitor power-up, gate exit from power-up
phase.
– Monitor disabled on phase0 entry.
– Monitor re-enabled in PHASE 3 on DCF rec
reading.
– Trigger destructive event reset during reset
— flow.
– Configuration is locked to enable during run
time.
After reset completion:
– LVD event demoted from destructive to
functional reset by software after reset
sequence completion.
– Monitor power-up, gate exit from power-up
phase.
– Monitor disabled on phase0 entry.
– Monitor re-enabled in PHASE 3 on DCF rec
— ENABLE
reading.
After reset completion:
– LVD event is also associated to an interrupt
event.
Default configuration (hysteresis monitor).
– Monitor power-up, gate exit from power-up
phase.
– Monitor disabled on phase0 entry.
— DISABLE
– Monitor re-enabled in PHASE 3 on DCF rec
reading.
After reset completion:
– see footnote
RM0400
Monitor status
4
(4)