Decimation Filter
Field
Integration Sum Value
The SUM_VALUE[31:0] field holds an unsigned number representing the sum of filtered
output values, continuously updated as the integration proceeds. The control of the
integration sum is determined by the register DECFILTER_MXCR (see <Cross
Refs>Section 37.3.2.3, "Decimation Filter Module Extended Configuration Register
(DECFILTER_MXCR)").
0-31
Note: If the DEFILTER_MXCR bit SSAT=1, the integration sum is saturated, so that if the
SUM_VALUE[31:0]
Note: A read on this register automatically commands an update of the register
37.3.2.12 Decimation Filter Current Integration Count Value register
(DECFILTER_CINTCNT)
Address: DECFILTER_BASE + 0x0EC
0
1
R
W
Reset
0
0
16
17
R
W
Reset
0
0
Figure 371. Decimation Filter Current Integration Count Value register (DECFILTER_CINTCNT)
Field
Integration Count Value
0-31
The COUNT field holds the count of filtered outputs integrated. The value is updated only
COUNT[31:0]
when register DECFILTER_CINTVAL is read, to keep the coherency between the integration
and count values.
37.4
Functional description
37.4.1
Overview
Figure 359
control signals for all other sub-modules.The data interface is sub-divided into two sub-
826/2058
Table 430. DECFILTER_CINTVAL field descriptions
accumulation overflows DECFILTER_CINTVAL holds the value 0xFFFFFFFF for
absolute integration (SSIG=0), or values 0x7FFFFFFF (positive saturation) and
0x80000000 (negative saturation) for signaled integration (SSIG=1). If SSAT=0,
DECFILTER_FINTVAL holds the integration sum modulo 2
fractional part).
DECFILTER_CINTCNT.
2
3
4
5
0
0
0
0
18
19
20
21
0
0
0
0
Table 431. DECFILTER_CINTCNT field descriptions
shows the block diagram of the Decimation Filter. The control logic provides the
DocID027809 Rev 4
Description
6
7
8
9
COUNT[31:16]
0
0
0
0
22
23
24
25
COUNT[15:0]
0
0
0
0
Description
17
(considering the 15-bit
Access: User read only
10
11
12
13
0
0
0
0
26
27
28
29
0
0
0
0
RM0400
14
15
0
0
30
31
0
0
Need help?
Do you have a question about the SPC572L series and is the answer not in the manual?
Questions and answers