Atm Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
ATM I
NTERFACE
To create a virtual asynchronous transfer mode (ATM) interface and/or activate the ATM Interface
Configuration mode, enter the interface atm command at the Global Configuration mode prompt. For
example:
>enable
#configure terminal
(config)#interface atm 1
(config-atm 1)#
By default, ATM interfaces are created as point-to-point links. This default setting cannot be altered. The
following command creates the exact same interface as that mentioned above:
>enable
#configure terminal
(config)#interface atm 1 point-to-point
(config-atm 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 1945
rtp quality-monitoring on page 1946
snmp trap on page 1947
snmp trap link-status on page 1948
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

ATM Interface Command Set

1944