ADTRAN AOS Version R10.1.0 Command Reference Manual page 1893

Command Reference Guide
snmp trap link-status
Use the snmp trap link-status command to control the Simple Network Management Protocol (SNMP)
variable ifLinkUpDownTrapEnable (RFC 2863) to enable (or disable) the interface to send SNMP traps
when there is an interface status change. Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the ifLinkUpDownTrapEnable object identifier (OID) is enabled for all interfaces except virtual
Frame Relay interfaces.
Command History
Release 1.1
Release 5.1
Release 6.1
Release 7.1
Release 8.1
Release 9.1
Release 11.1
Release 16.1
Functional Notes
The snmp trap link-status command is used to control the RFC 2863 ifLinkUpDownTrapEnable OID (OID
number 1.3.6.1.2.1.31.1.1.1.14.0).
Usage Examples
The following example disables the link-status trap on the serial interface:
(config)#interface serial 1/1
(config-ser 1/1)#no snmp trap link-status
60000CRG0-35E
Command was introduced.
Command was expanded to include the Ethernet subinterfaces and Gigabit
Ethernet interfaces.
Command was expanded to include the E1, port channel, T3, and virtual
local area network (VLAN) interfaces.
Command was expanded to the high speed serial interface (HSSI).
Command was expanded to the asynchronous transfer mode (ATM)
interface.
Command was expanded to the high level data link control (HDLC)
interface.
Command was expanded to the demand interface.
Command was expanded to the tunnel interface.
Copyright © 2012 ADTRAN, Inc.
Serial Interface Command Set
1893