ADTRAN AOS Version R10.1.0 Command Reference Manual page 1883

Command Reference Guide PRI Interface Command Set
snmp trap link-status
Use the snmp trap link-status command to control the Simple Network Management Protocol (SNMP)
variable ifLinkUpDownTrapEnable (RFC 2863) to enable (or disable) the interface to send SNMP traps
when there is an interface status change. Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the ifLinkUpDownTrapEnable object identifier (OID) is enabled for all interfaces except virtual
Frame Relay interfaces.
Command History
Release A5.01 Command was introduced.
Functional Notes
The snmp trap link-status command is used to control the RFC 2863 ifLinkUpDownTrapEnable OID (OID
number 1.3.6.1.2.1.31.1.1.1.14.0).
Usage Examples
The following example disables the link-status trap on the primary rate interface (PRI) 2:
(config)#interface pri 2
(config-pri 2)#no snmp trap link-status
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 1883