ADTRAN AOS Version R10.1.0 Command Reference Manual page 1896

Command Reference Guide
alarm-threshold
Use the alarm-threshold command to set thresholds for specific alarm conditions. Use the no form of this
command to disable threshold settings. Variations of this command include:
alarm-threshold loop-attenuation <value>
alarm-threshold snr-margin <value>
Syntax Description
loop-attenuation <value>
snr-margin <value>
Default Values
No default values are necessary for this command.
Command History
Release 3.1
Usage Examples
The following example sets the loop attenuation threshold at 45 dB:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#alarm-threshold loop-attenuation 45
60000CRG0-35E
Specifies a loop-attenuation threshold value from 1 to 127 dB. If signal
energy loss on the loop exceeds the configured value, the router issues an
alarm.
Specifies a value for signal-to-noise ratio (SNR) margin from 1 to 15 dB. If
the difference in amplitude between the baseband signal and the noise
exceeds the configured value, the router issues an alarm.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
SHDSL Interface Command Set
1896