Atm Subinterface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
ATM S
UBINTERFACE
To create a virtual asynchronous transfer mode (ATM) subinterface and/or activate the ATM Subinterface
Configuration mode, enter the interface atm command (and specify a subinterface) at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface atm 1.1
(config-atm 1.1)#
By default, ATM subinterfaces are created as point-to-point links. This default setting cannot be altered.
The following command creates the exact same interface as that mentioned above:
>enable
#configure terminal
(config)#interface atm 1.1 point-to-point
(config-atm 1.1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
atm routed-bridged ip on page 1951
bandwidth <value> on page 1952
bridge-group <value> on page 1953
cos on page 1954
crypto map <name> on page 1956
dial-backup commands begin on page 1958
dynamic-dns on page 1975
encapsulation on page 1977
fair-queue on page 1978
hold-queue <value> out on page 1979
ip commands begin on page 1980
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

ATM Subinterface Command Set

1949