ADTRAN AOS Version R10.1.0 Command Reference Manual page 1870

Command Reference Guide
digits-transferred <value>
Use the digits-transferred command to define how many of the received digits should be sent to the
internal switchboard from an incoming call on a trunk. The number of digits transferred are the least digits
received. Direct inward dialing (DID) should be used if a Telco provider is providing digits to the unit on
inbound calls or if the unit needs to provide DID information to a piece of customer premises equipment
(CPE). Use the no form of this command to disable this feature. Variations of this command include:
digits-transferred <value>
digits-transferred <value> no-prefix
digits-transferred <value> prefix <number>
Syntax Description
<value>
no-prefix
prefix <number>
Default Values
No default values are necessary for this command.
Command History
Release 14.1
Usage Examples
The following example transfers the digits 555-8000 and adds the prefix 256:
(config)#interface pri 2
(config-pri 2)#digits-transferred 5558000 prefix 256
60000CRG0-35E
Specifies the number of digits to be transferred. The valid number of digits
are 0, 3, 4, 7 or all.
Optional. Specifies transferring the DID digits without appending a prefix.
Optional. Specifies a sequence of digits to be appended to the digits that will
be transmitted. For example, if seven digits will be transferred via DID, then
prefix the seven digits with 256. Thus, 555-8000 would be prefixed with 256,
and 256-555-8000 would not.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
PRI Interface Command Set
1870