Modem Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
M I
ODEM NTERFACE
To activate the Modem Interface Configuration mode, enter the interface modem command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface modem 1/2
(config-modem 1/2)#
The modem interface number in the example above is shown as modem 1/2. This number is
based on the interface's location (slot/port) and could vary depending on the unit's
configuration. Use the do show interfaces command to determine the appropriate
interface number.
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
caller-id-override on page 1860
dialin on page 1861
init-string <string> on page 1862
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 1863
resource pool-member on page 1864
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

Modem Interface Command Set

1859