ADTRAN AOS Version R10.1.0 Command Reference Manual page 1867

Command Reference Guide
calling-party name-facility-timeout <value>
Use the calling-party name-facility-timeout command to set the name facility timeout. This value
determines the number of seconds to wait for the calling-party name delivery after the initial SETUP
message is received. Once the name delivery is received or the timeout has passed, the corresponding
INVITE is sent using the Session Initiation Protocol (SIP) trunk. Set the value to 0 to eliminate the delay.
Use the no form of this command to return to the default setting.
Syntax Description
<value>
Default Values
By default, the timeout is 2 seconds.
Command History
Release A2.03
Usage Examples
The following example sets the calling-party name-facility-timeout to 5 seconds:
(config)#interface pri 2
(config-pri 2)#calling-party name-facility-timeout 5
60000CRG0-35E
Sets the number of seconds to wait for the calling-party name delivery. Valid
range is 0 to 5.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
PRI Interface Command Set
1867