Pri Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
PRI I
NTERFACE
To activate the PRI Interface Configuration mode, enter the interface pri command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface pri 2
(config-pri 2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
description <text> on page 70
do on page 71
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
calling-party on page 1866
calling-party name-facility-timeout <value> on page 1867
connect e1<slot/port> tdm-group <number> on page 1868
connect t1 <slot/port> tdm-group <number> on page 1869
digits-transferred <value> on page 1870
isdn alert disable pi-8 on page 1871
isdn connect enable pi-2 on page 1872
isdn name-delivery on page 1873
isdn pi-location on page 1874
isdn ringing-signal on page 1875
isdn setup enable on page 1876
isdn supplementary-service on page 1877
isdn switch-type on page 1879
redirecting-number on page 1880
role on page 1881
snmp trap on page 1882
snmp trap link-status on page 1883
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

PRI Interface Command Set

1865