ADTRAN AOS Version R10.1.0 Command Reference Manual page 1908

Command Reference Guide SHDSL Interface Command Set
outage-retrain
Use the outage-retrain command to cause the single-pair high-speed digital subscriber line (SHDSL)
interface to force the SHDSL retrain sequence (which takes the line down temporarily) if the interface
detects more than ten consecutive errored seconds. A retrain is forced in hopes that the newly retrained line
will achieve better performance than the previous training state. Use the no form of this command to
disable this feature.
Syntax Description
No subcommands.
Default Values
By default, this feature is disabled.
Command History
Release 3.1 Command was introduced.
Usage Examples
The following example forces a retrain sequence on the SHDSL interface:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#outage-retrain
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 1908