T1 Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
T1 I
NTERFACE
To activate the T1 Interface Configuration mode, enter the interface t1 command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface t1 1/1
(config-t1 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
clock source on page 1914
coding on page 1915
fdl on page 1916
framing on page 1917
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 1918
lbo on page 1919
loopback commands begin on page 1920
remote-alarm rai on page 1923
remote-loopback on page 1924
snmp trap line-status on page 1925
snmp trap link-status on page 1926
snmp trap threshold-reached on page 1927
system-timing on page 1928
tdm-group <number> on page 1929
test-pattern on page 1930
timing-domain <domain> on page 1931
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

T1 Interface Command Set

1913