Table of Contents
Advertisement
Command Reference Guide
framing
Use the framing command to configure the framing format for the T1 interface. This parameter should
match the framing format supplied by your network provider. Use the no form of this command to return
to the default value. Variations of this command include:
framing d4
framing esf
Syntax Description
d4
esf
Default Values
By default, the framing format is set to esf.
Command History
Release 1.1
Functional Notes
A frame is comprised of a single byte from each of the T1's timeslots; there are 24 timeslots on a single T1
circuit. Framing bits are used to separate the frames and indicate the order of information arriving at the
receiving equipment. D4 and ESF are two methods of collecting and organizing frames over the circuit.
Usage Examples
The following example configures the T1 interface for D4 framing:
(config)#interface t1 1/1
(config-t1 1/1)#framing d4
60000CRG0-35E
Specifies D4 superframe (SF) format.
Specifies extended superframe (ESF) format.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
T1 Interface Command Set
1917
Advertisement
Table of Contents
