T3 Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
T3 I
NTERFACE
To activate the T3 Interface Configuration mode, enter the interface t3 command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface t3 1/1
(config-t3 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
clock source on page 1933
coding b3zs on page 1934
framing on page 1935
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 1936
line-length on page 1937
loopback network on page 1938
loopback remote on page 1939
remote-loopback on page 1940
snmp trap link-status on page 1941
test-pattern on page 1942
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

T3 Interface Command Set

1932