ADTRAN AOS Version R10.1.0 Command Reference Manual page 1905

Command Reference Guide
linerate <value>
Use the linerate command to define the line rate for the single-pair high-speed digital subscriber line
(SHDSL) interface (the value includes 8 kbps of framing overhead). This command is functional only in
CO operating mode (refer to
line interface (CLI) (72 and 136 kbps) are not supported by the SHDSL network interface module (NIM)
(P/N 1200867L1). Use the no form of this command to return to the default setting.
Syntax Description
<value>
Default Values
By default, the line rate is set to 2056 kbps.
Command History
Release 3.1
Usage Examples
The following example changes the line rate of the SHDSL interface to 264 kbps:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#linerate 264
60000CRG0-35E
equipment-type on page
Specifies the line rate in kbps. Range is 200 to 2312 kbps in 64k
increments.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
SHDSL Interface Command Set
1899). The first two selections listed in the command
1905