Shdsl Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
SHDSL I
NTERFACE
To activate the Single-Pair High-Speed Digital Subscriber Line (SHDSL) Interface Configuration mode,
enter the interface shdsl command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface shdsl 1/1
(config-shdsl 1/1)#
Not all SHDSL commands apply to all SHDSL interfaces. Type interface shdsl <slot/port>
to display a list of valid commands.
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
alarm-threshold on page 1896
annex on page 1897
boot alternate-image on page 1898
equipment-type on page 1899
ignore-error-duration <time> on page 1900
inband-detection on page 1901
inband-protocol on page 1902
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 1903
line-mode on page 1904
linerate <value> on page 1905
loopback on page 1906
loopback remote inband on page 1907
outage-retrain on page 1908
test-pattern on page 1909
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

SHDSL Interface Command Set

1894