ADTRAN AOS Version R10.1.0 Command Reference Manual page 1910

Command Reference Guide
test splice-detect distance-type
Use the test splice-detect distance-type command to specify the unit of measurement used in the bad
splice detection test. Use the no form of this command to return to the default unit of measurement.
Variations of this command include:
test splice-detect distance-type feet
test splice-detect distance-type meters
Syntax Description
feet
meters
Default Values
By default, distances in the bad splice detection test are measured in feet.
Command History
Release A4.05
Functional Notes
The bad splice detection test is a line testing feature that allows users to locate intermittent faults in lines
by estimating the distance to the fault. Splice detection is always enabled on the SHDSL EFM NIM2
module and it continually monitors the signal-to-noise ratio (SNR) of the connection. When a negative
change in the SNR is detected, a measurement is taken to determine the distance to where the issue is
possibly occurring on the line. Bad splice detection test results can be viewed using the command
interface shdsl <slot/port> splice-detect on page
Usage Examples
In the following example, the unit of measurement used by the bad splice detection test is changed from
feet to meters:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#test splice-detect distance-type meters
60000CRG0-35E
Specifies the distance to the detected bad splice is measured in feet.
Specifies the distance to the detected bad splice is measured in meters.
Command was introduced.
536.
Copyright © 2012 ADTRAN, Inc.
SHDSL Interface Command Set
show
1910