Serial Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
S I
ERIAL NTERFACE
To activate the Serial Interface Configuration mode, enter the interface serial command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface serial 1/1
(config-ser 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
et-clock-source on page 1885
ignore dcd on page 1886
invert etclock on page 1887
invert rxclock on page 1888
invert txclock on page 1889
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 1890
serial-mode on page 1891
snmp trap on page 1892
snmp trap link-status on page 1893
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

Serial Interface Command Set

1884