ADTRAN AOS Version R10.1.0 Command Reference Manual page 1939

Command Reference Guide
loopback remote
Use the loopback remote command to initiate a loopback test on the T3 interface that sends a remote
loopback code out the T3 circuit to loop up the far end. This command only applies when C-bit framing is
used on the circuit. Use the no form of this command to deactivate the loopback. Variations of this
command include:
loopback remote line
loopback remote payload
Syntax Description
line
payload
Default Values
No default values are necessary for this command.
Command History
Release 6.1
Usage Examples
This example initiates a remote loopback on the T3 interface:
(config)#interface t3 1/1
(config-t3 1/1)#loopback remote
60000CRG0-35E
Initiates a line loopback.
Initiates a payload loopback.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
T3 Interface Command Set
1939