ADTRAN AOS Version R10.1.0 Command Reference Manual page 1876

Command Reference Guide
isdn setup enable
Use the isdn setup enable command to enable progress indicators in the integrated services digital
network (ISDN) setup message and redirecting numbers for ISDN calls on the primary rate interface (PRI).
The redirecting number is used to insert the caller's number when a call is diverted by a blind transfer or
forward that both occurs on an ISDN trunk in local mode and proceeds out of an ISDN trunk. Use the no
form of this command to disable this feature. Variations of this command include:
isdn setup enable pi-1
isdn setup enable pi-3
isdn setup enable redirecting-number
Syntax Description
pi-1
pi-3
redirecting-number
Default Values
No default values are necessary for this command.
Command History
Release A4.01
Release A4.03
Usage Examples
The following example enables redirecting numbers for ISDN calls:
(config)#interface pri 2
(config-pri 2)#isdn setup enable redirecting-number
60000CRG0-35E
Enables progress indicator 1 for ISDN setup messages. Progress indicator
1 indicates that the call is not end-to-end ISDN and further call progress
information may be available in-band.
Enables progress indicator 3 for ISDN setup messages. Progress indicator
3 indicates that the origination address is non-ISDN.
Enables redirecting numbers for ISDN calls.
Command was introduced.
Command was expanded to include the redirecting-number parameter.
Copyright © 2012 ADTRAN, Inc.
PRI Interface Command Set
1876