ADTRAN AOS Version R10.1.0 Command Reference Manual page 1882

Command Reference Guide PRI Interface Command Set
snmp trap
Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP) traps
on the interface. Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and subinterfaces) have SNMP traps
enabled.
Command History
Release A5.01 Command was introduced.
Usage Examples
The following example enables SNMP on the primary rate interface (PRI) 2:
(config)#interface pri 2
(config-pri 2)#snmp trap
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 1882