ADTRAN AOS Version R10.1.0 Command Reference Manual page 1977

Command Reference Guide
encapsulation
Use the encapsulation command to configure the encapsulation type for the ATM Adaptation Layer
(AAL) of the Asynchronous Transfer Mode (ATM) Protocol Reference Model. Use the no form of this
command to return to the default setting. Variations of this command include:
encapsulation aal5mux ip
encapsulation aal5mux ppp
encapsulation aal5snap
Syntax Description
aal5mux ip
aal5mux ppp
aal5snap
Default Values
By default, the encapsulation type is aal5snap.
Command History
Release 8.1
Functional Notes
For PPP and Point-to-Point Protocol over Ethernet (PPoE), the encapsulation type can be aal5snap or
aal5mux ppp. For IP with no bridging, the encapsulation type can be aal5snap or aal5mux ip. For IP with
bridging, the encapsulation type can only be aal5snap. For bridging, the encapsulation type can only be
aal5snap.
Usage Examples
The following example sets the encapsulation type to aal5snap:
(config)#interface atm 1.1
(config-atm 1.1)#encapsulation aal5snap
60000CRG0-35E
Specifies encapsulation type for multiplexed virtual circuits using the IP
protocol.
Specifies encapsulation type for multiplexed virtual circuits using the
Point-to-Point Protocol (PPP).
Specifies encapsulation type that supports LLC/SNAP protocols.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
ATM Subinterface Command Set
1977