Freescale Semiconductor PowerQUICC MPC885 Reference Manual page 731

Table 25-7 describes SCCE/SCCM fields.
Bits Name
0–2 — Reserved, should be cleared.
3 GLR Glitch on Rx. Set when the SCC finds a Rx clock glitch.
4 GLT Glitch on Tx. Set when the SCC finds a Tx clock glitch.
5–6 — Reserved, should be cleared.
7 IDL Idle sequence status changed. Set when serial line status changes. Real-time status can be read in
SCCS[ID].
8 — Reserved, should be cleared.
9 BRKE Break end. Marks the end of a break sequence—set when an idle bit is detected after a break
sequence.
10 BRKS Break start. Set when the first break character of a break sequence is received. Only one BRKS
event occurs per break sequence, no matter the length of the sequence.
11 TXE Tx error. Set when an error occurs on the transmitter channel.
12 RXF Rx frame. Set when the number of frames specified in RFTHR are received. RXF is set no sooner
than when the midpoint of the closing flag's stop bit arrives.
13 BSY Busy condition. Set when a frame is received and discarded due to a buffer shortage.
14 TXB Transmit buffer. Set when a buffer with TxBD[I] set is sent on the channel, not before the last bit of
the closing flag begins its transmission if the buffer is the last one in the frame. Otherwise, TXB is
set after the last byte of the buffer is written to the Tx FIFO.
15 RXB Rx buffer. Set when a buffer with RxBD[I] set and RxBD[L] cleared is received over the channel.
25.13.2 SCC Asynchronous HDLC Status Register (SCCS)
The SCC asynchronous HDLC status register (SCCS), shown in
of RXD. The real-time status of CTS and CD is part of the port C parallel I/O.
0
Field
Reset
R/W
Addr
Figure 25-5. SCC Status Register for Asynchronous HDLC Mode (SCCS)
Freescale Semiconductor
Table 25-7. SCCE/SCCM Field Descriptions
—
0000_0000_0000_0000
0xA37 (SCCS2), 0xA57 (SCCS3), 0xA77 (SCCS4)
MPC885 PowerQUICC Family Reference Manual, Rev. 2
SCC Asynchronous HDLC Mode and IrDA
Description
Figure 25-5, monitors the real-time status
R
6 7
ID
25-9