Connecting The Cable And The Wall Sockets To The Internal S Port (Internal S Bus) - Auerswald COMpact 4000 Operation Manual

Installation and Commissioning
ISDN End Devices
Connecting the Cable and the Wall Sockets to the Internal S
PTP Wiring
The point-to-pint wiring with a single wall socket at the end is suited for the connection of a
single end device at a very large distance. It supports cable lengths of up to 1000 m. The termi-
nators have to be switched on at the internal S
Connecting the Cable and the Wall Sockets to the Internal S
Bus)
Requirements:
• Cover panel is removed
• Enabled operating mode "S
Note: The default setting is „S
• Terminators enabled or disabled at the internal S
80
Port (Internal S
0
port. See the following figure.
0
internal" on the S
0
external" for port 1 and „S
0
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Bus)
0
0
port in question
0
internal" for port 2.
0
port, depending on the bus variant
0
Port (Internal S
0