Installation and Commissioning
ISDN End Devices
Connecting the Cable and the Wall Sockets to the Internal S
PTP Wiring
The point-to-pint wiring with a single wall socket at the end is suited for the connection of a
single end device at a very large distance. It supports cable lengths of up to 1000 m. The termi-
nators have to be switched on at the internal S
Connecting the Cable and the Wall Sockets to the Internal S
Bus)
Requirements:
• Cover panel is removed
• Inserted COMpact 2BRI module
• Enabled operating mode "S
92
Port (Internal S
0
0
internal" on the S
0
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
Bus)
0
port. See the following figure.
port in question
0
Port (Internal S
0
0