Switching Subscriber Call Forwarding Only For External Calls On/Off - Auerswald COMpact 4000 Operation Manual

Functions
Call Forwarding

Switching Subscriber Call Forwarding Only for External Calls On/Off

If you configure an internal telephone as the forwarding destination, it
requires at least partial exchange line authorisation for forwarded external
calls Only incoming, with emergency call.
To avoid having to use a second call channel in the case of call forwarding to
an external destination, the PBX tries to reroute the call directly at the
network provider using call deflection. The following requirements must be
fulfilled for this purpose: 1. The incoming call was made via an ISDN network
provider supporting call deflection. 2. The rerouted phone number is neither
called as a group member, nor is it required to consider parallel calling or
fallback on busy.
Further steps:
• To remind you having configured call forwarding on your telephone, you can switch on a
special dial tone (Subscriber (scr.) > Properties > Signallisation by tones).
Switching Subscriber Call Forwarding Only for External Calls On/Off
If call forwarding for subscribers (unconditional, on busy, on no reply) is only performed for
external calls,only external calls will be forwarded.
Proceed as follows:
• Separately for subscribers
• Separately for configurations
• Using the configuration manager
Note: As described in the following, the setting is also possible via profiles (...
> Profiles > Configuration > Configure > ...). If the check box Profile-
controlled settings has been selected, the property set in the right-hand
column will apply. For assignment of the profile, see chapter Settings >
Profiles.
1. Open the following page:
• For admin: Subscriber (scr.) > Properties > Reachability
• For user: Subscriber Properties > Reachability.
450
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016