Group Properties Via Group Profiles; Creating Profiles - Auerswald COMpact 4000 Operation Manual

Pbx for analogue/isdn/internet telephony

Hide thumbs Also See for COMpact 4000:

Table of Contents

Group Properties via Group Profiles

Different profiles may be assigned to a Group depending on configurations. These profiles

control the behaviour of the logged-in group members.

This is the mode of action of the individual functions:

• First it will be checked which configuration and with that which profile is valid for the corre-

sponding group. If this setting was configured inside of this profile not to be changed

(Profile-controlled settings enabled), the function properties are already fixed.

• If this setting was allowed to be changed inside of this profile (Profile-controlled settings

disabled), the configuration of page Groups > Properties will be enabled.

Note: When entering the internal number for the very first time (see Groups

> Phone numbers) a group will be assigned to the standard profile automat-

ically. For the standard profile (see Groups > Profiles > Configuration) the

default authorisation is to change the function settings (Profile-controlled

settings disabled -> no). That means that each function will be switched as

it was entered on the page Groups > Properties.

Changes to function settings may be made by:

• Configuration switchover (with different profiles in these configurations)

• Telephone procedures (only if the function changes are allowed in the profile settings

(Profile-controlled settings disabled))

• User action on the page Groups > Properties of the configuration manager (only if the

function changes are allowed in the profile settings (Profile-controlled settings disabled).

In addition to this the user needs a user password and the authorisation for the page

mentioned above.

The available profiles (default profiles, user-defined profiles) are displayed in the Profile name

• Default profiles: The selected settings can be viewed by means of clicking View in the last

• User-defined profiles: The user-defined profiles can be adapted to the corresponding

requirements by means of clicking Configure in the last column.

COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016

Show Quick Links

Table of Contents