Exchange Line Request - Auerswald COMpact 4000 Operation Manual

Settings

Exchange Line Request

Switching Authorisation for Controlling the PBX On/Off
Exchange Line Request
The PBX distinguishes three types of exchange line requests:
Internal telephone: The user has to dial an external number with preceding
access number.
Direct exchange line telephone: For an external number no prefix is required. However, the
user has to dial an internal number with preceding **.
Automatic exchange line request (factory setting): Neither for the internal nor for the external
number a prefix is required. The PBX automatically distinguishes between internal and external
numbers with the adjustment of the dialled phone number and the internal numbering plan:
• If the phone number is contained in the telephone numbering list, the PBX establishes an
internal connection.
• If the phone number is not contained in the telephone numbering list, the PBX establishes
an external connection.
Notes:
The short code number is a part of the internal numbering plan and is
therefore an internal number. However it leads to an external connection.
In order that the distinction between internal numbers and phone numbers in
the local area network functions, the internal numbering plan must not
contain phone numbers that also occur within the local area network. To
avoid conflicts, phone numbers of the local area network should always be
dialled with local area code.
Also when the entered phone number correspond with the internal telephone
numbering plan, the PBX waits 4 seconds for whether additional digits for an
external number are being entered, before it dials the internal phone number.
To avoid waiting time, you can subsequently enter #. The PBX therefore
recognises the input as finished and instantly starts dialling.
In factory settings, the system-wide automatic exchange line request (for all
subscribers) is switched on. Alternatively, the exchange line request type can
be set separately for each subscriber. In this case, the automatic exchange
line request can only be selected for IP DECT telephones. For all other
subscribers, only direct exchange line telephone and internal telephone can
be selected.
684
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
exchange line