Factory Settings; Restore Factory Settings - Auerswald COMpact 4000 Operation Manual

Service and Maintenance

Factory Settings

Restore Factory Settings

Factory Settings
The factory settings represent the condition of a device before it is configured using a computer
or telephone.
Restore Factory Settings
If the factory settings on the PBX are restored, all of the settings are deleted or reset to the
original settings before the device was first configured.
Warning: Touching voltage-carrying conductors or telephone connections
can cause life-threatening electric shocks.
• For some installation and maintenance work, it is necessary to open the
• Only a qualified electrician may perform installation work within an open
Warning: Power surges, which can occur during electrical storms, can
cause life-threatening electric shocks and damage or destroy the PBX.
• Do not open the PBX during an electrical storm.
Important: This function requires performing the steps rapidly. Make sure
you are comfortable with the procedure before you begin.
1. Press the Reset button on the COMpact 4000 interface board.
744
PBX while it is in operation (qualified electrician only). Make sure that the
PBX is never left unattended while working with an open casing. Close
the casing after completing this work.
casing or service work using the buttons inside the casing. If necessary,
commission an authorised dealer to perform this work.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016