Auerswald COMpact 4000 Operation Manual page 456

Functions
Call Forwarding
Switching Call Forwarding for Groups On/Off
Proceed as follows:
• Separately for groups
• Separately for configurations
• Using the configuration manager
• Using a character string on the internal telephone (see section Short Reference)
Note: As described in the following, the setting is also possible via profiles (...
> Profiles > Configuration > Configure > ...). If the check box Profile-
controlled settings has been selected, the property set in the right-hand
column will apply. For assignment of the profile, see chapter Settings >
Profiles.
1. Open the following page:
• For admin: Groups > Properties > Reachability
• For user: Group Properties > Reachability.
2. In the list field at the top, select the group in question by its name or number.
3. Depending on the call forwarding type desired, select or clear one of the following
check boxes CF immediately or CF on busy or CF on no reply or CF if all are
logged out.
4. If you have enabled a call forwarding type, enter the destination number in the Desti-
nation number entry field under the desired call forwarding type CF immediately, or
CF on busy, or CF on no reply or CF if all are logged out. Possible entries:
External number
Short-code number
Internal number of the individual telephone
Internal number of the group
Note:
The phone number entered under Destination number is preserved even if
the corresponding check box is cleared.
If you configure an internal telephone as the forwarding destination, it
requires at least partial exchange line authorisation for forwarded external
calls Only incoming, with emergency call.
456
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016